Customer Build - Chopped M72 4.5mm SF with M76 FSB on the best receivers made. The one and only. Childers.
Just don't forget to mill the under carriage of the ft for the latch to fit.
https://www.facebook.com/ChildersGuns/posts/1881358055468311
Latch pin hole was milled down approximately half a mm for the pin spring to latch.
Believe the mill bit size is 7 mm. We used one slightly bigger.
Just take a little bit off at a time until the latch pin sits deep enough for the spring to catch.
Just don't forget to mill the under carriage of the ft for the latch to fit.
https://www.facebook.com/ChildersGuns/posts/1881358055468311
Latch pin hole was milled down approximately half a mm for the pin spring to latch.
Believe the mill bit size is 7 mm. We used one slightly bigger.
Just take a little bit off at a time until the latch pin sits deep enough for the spring to catch.
